Drop Beam
Question:
Hello There,
Kindly advise, If have a drop beam at the drop area as per below image, can midas gen identify my drop beam. If not then I have to create the beam, but how?
Thanks & regards,
Hello There,
Kindly advise, If have a drop beam at the drop area as per below image, can midas gen identify my drop beam. If not then I have to create the beam, but how?
Thanks & regards,
Answer:
Hello,
Thank you for your patient.
We support the uniformed section beam and tapered section beam. Therefore, (1) create the two type sections (350&300). (2) Divide the part that has different height section. (3) Generate the drop beam using two beams.
Thank you.
Best Regards,
Jihong Hwang
Thank you for your patient.
We support the uniformed section beam and tapered section beam. Therefore, (1) create the two type sections (350&300). (2) Divide the part that has different height section. (3) Generate the drop beam using two beams.
Thank you.
Best Regards,
Jihong Hwang
Files | ||
---|---|---|
DataImage69.png 182 KB |
||
DataImage47.png 35 KB |