Re-merging Divided Planar Elements
Question:
Lets say the planar elements (slab, wall etc) in a model which has been meshed into smaller pieces. Is it possible to re-merge the divided planar elements into a single piece again (without using undo) after analysis or after turn on the software again upon shut down?
Lets say the planar elements (slab, wall etc) in a model which has been meshed into smaller pieces. Is it possible to re-merge the divided planar elements into a single piece again (without using undo) after analysis or after turn on the software again upon shut down?
Answer:
Hello,
Unfortunately, it is impossible to merge the meshed plates into one element.
Thank you.
Best regards,
Jihong Hwang
Unfortunately, it is impossible to merge the meshed plates into one element.
Thank you.
Best regards,
Jihong Hwang