Servicebility steel check
Question:
Hi all,
please consider the model attached.
We can not understand why Midas doesn't give the correct value of the deformation check.
The correct values is 2.28 - (0.71+0.22)/2 = 1.815mm
Can you help us please?
Thank you very much.
kind regards
Hi all,
please consider the model attached.
We can not understand why Midas doesn't give the correct value of the deformation check.
The correct values is 2.28 - (0.71+0.22)/2 = 1.815mm
Can you help us please?
Thank you very much.
kind regards
Answer:
Hello,
This is because of the member assignment. As shown in the image below, the member should be separated on the vertical element. The deflection will be calculated considering the deflection on nodes which is connected with the vertical element.
Thank you.
Best regards,
Jihong Hwang
This is because of the member assignment. As shown in the image below, the member should be separated on the vertical element. The deflection will be calculated considering the deflection on nodes which is connected with the vertical element.
Thank you.
Best regards,
Jihong Hwang
DataImage13.png
DataImage46.png
piping support.mgb
| Files | ||
|---|---|---|
|
|
DataImage13.png
464 KB
|
|
|
|
DataImage46.png
237 KB
|
|
|
|
piping support.mgb
126 KB
|