Applying UDL load on Composite Member

Question:

Hi Madam/Sir

I have a model with composite section of beam and top slab with diaphragms. I would like to check if there is a way to apply area load on the slab surface? 

In the above model, I would like to apply area load to the plane defined by node (21.30.40.31). However, some plane inside only have 3 edge support so it's not possible to put the floor loads. For example, i can put the load on (19,17,18,20) but i cannot put load on (30,19,17,29).

Is there a way to apply area load on the above problem.

Thanks.


Answer:

Hi,

You can do it with the Floor Load function below. Please refer to the online help for details.

Regards,
DK Lee
Creation date: 8/2/2018 12:20 PM (dklee@midasit.com)      Updated: 8/2/2018 9:50 PM (dklee@midasit.com)
Files   
DataImage68.png
resend
DataImage74.png
resend
DataImage84.jpeg
resend