Convergence

Question:

How can I pass through error 2103?
How can I see the partial results from the phase that did't convergeted
Software offers me only the previous finished phase.
Maybe it is a problem in the mesh, soil, sonstruction ect…
I only see the information error 2103, nothing else, how can I solve the problem if I don't see the partial results?
Regards

Answer:

Dear Customer,

1) How can i pass through error 2103?

     We are checking now.

2) How can i see the partial results from the phase that didn't converged?

     You can try as what i attached, then, you can see separated steps from result work-tree

And, please reply on this comment for keeping to open this query.


Thanks N Regards

Choi, Youngho
MIDAS Global Technical Center


Dear Customer,

For 1) How can i pass through error 2103?

           I'm recommending you to carry out the analysis with initial stiffness scheme as you can see below,
     
           You can use this method when the non-linearity is so weak with your material properties.

           
           
           Or, if you can't pass with this method, It is hard to solve with changing the convergence method.

           So, Please increase the strength of soil material or install more structural reinforcement.


Thanks N Regards,

Choi, Youngho
MIDAS Global Technical Center 
           


Thank you for the answer
Regards

Creation date: 3/4/2019 1:56 AM (cyh1220)      Updated: 3/11/2019 7:27 AM (dklee@midasit.com)
Files   
1. Zid+Sidro_h=6.0 m.rar
resend
2. To make the partial steps from 1 phase.docx
resend
2019-02-26_11-22-37.jpg
resend
DataImage32.png
resend