What steps can be taken to solve the issue of relevant loading data disappearing from the work tree and relevant input information missing from the load table when switching to post-processing mode after performing construction stage analysis, specifically in the case of CS3?
Answer:
This is happening because the first step is the default in the post-processing mode but the last step is the default in the pre-processing mode. The load group is applied at the middle step of the CS3. Thus, it is shown in the pre-processing mode and not in the post-processing mode. In order to see the load group in the post-processing mode, you need to change the step to 'User step' or 'Last step' as shown below.
DataImage80.png
CS3_Pre.jpg
FCM-R2.mcb
CS3_Post.jpg
| Files | ||
|---|---|---|
|
|
DataImage80.png
55 KB
|
|
|
|
CS3_Pre.jpg
230 KB
|
|
|
|
FCM-R2.mcb
4 MB
|
|
|
|
CS3_Post.jpg
194 KB
|